Remington BV12200A, BV1220DAT Manuel du propriétaire Page 12

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 18
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 11
8 | Chapter 4: Blower/Vac Operation
120133
Operating the
Blower/Vac
e on/off toggle switch has three settings;
off, low, and high. e middle switch po-
sition, marked “O”, is off. e rear switch
position, marked I”, is low. e forward
switch position, marked “II”, is high. See
Figure 4-4.
Blower Operation
Figure 4-4: On/O switch positions
Figure 4-5: Holding blower/vac for blower operation
Figure 4-7: Operating blower
WARNING: The blower can
throw debris, causing injury to
those nearby.
Do not blow nails, bolts, rocks,
or other hard objects.
Do not operate blower near
bystanders or pets.
Be careful when blowing de
-
bris from stairs, corners, or
other tight areas. Objects can be
blown back toward operator.
Wear approved eye protection,
long pants, and shoes while
operating this blower/vac.
Properly assemble the blower/vac for
blower operation (see page 4, Assembling
Blower). Follow the steps below to operate
the blower.
1. Hold blower/vac using the handle on
housing (see Figure 4-5).
2. When ready to start the blower, toggle
the on/off switch to either the low I
or high II setting (see Figure 4-6).
3. To stop the blower, toggle the on/off
switch to the off O setting.
Figure 4-6: On/O Switch to LOW position
Vue de la page 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18

Commentaires sur ces manuels

Pas de commentaire