Remington RM1632A Manuel du propriétaire télécharger pdf (Page 16)

CLEANING AND MAINTENANCE

NOTICE: Below are instructions for ser-

vicing your chain saw. Any servicing not

mentioned below should be done by an

authorized service center.

CLEANING SAW BODY

_, WARNING: Unplug chain saw from

powersource beforeservicing. Severeinjury

or death could occur from electricN shock

or body contact with moving chain.

_ WARNING: Cutting edges on chain

are sharp. Use protective gloves when

handling chain.

• lk WARNING: When cleaning saw body,

• do not submerge saw in any liquids

• do not use products that contain am-

monia, chlorine, or abrasives

• do not use chlorinated cleaning sol-

vents, carbon tetracMoride, kerosene,

or gasoline

Keep saw bodyclegm.Use asoftcloth dampened witha

mildsoap and water mixture.Wipe saw N_dyto clean.

CARE OF GUIDE BAR

Uneven bar wear causes most guide bar problems.

Incorrect sharpening of chain cutter and depth gauge

settings often cause this. When bar wears unevenly,

it widens guide bar groove (see Figure 18). This

causes chain clatter and rivet popping. Saw will not

cut straight. Replace guide bar if this occurs.

Inspect guide bar before shaq)ening chain. A worn or

demagedguide /jointfilesconvert/376389/bguisunsafe. Aworn or damagedguide

bar willdemage chain. It will alsomake cutting hguder.

j_ Guide Bar Groove \ \

Guide Bar

Normal Guide Guide Bar With

Bar UneveR Wear

Figure 18 - Guide Bar Cross Section Showing

Uneven Bar Wear

Normal Guide Bar Maintenance

1. Remove guide bar flom chain saw.

2. Remove sawdust flom guide bar groove periodi-

cally. Use putty knife or wire (see Figure 19).

3. Clean oil slots after each day of use.

4. Remove burrs from sides of guide bar. Use flat

file to make side edges square.

Replace guide bar when

• bar is bent or cracked

• inside groove of bar is badly worn

Note: When replacing guide bar, see Ru)laceme_Tt

Partx and Accexsories for proper bar.

SHARPENING SAW CHAIN

_lb WARNING: Unplug chain saw from

powersource beforeservicing. Severeinjury

or death could occur from electrical shock

or body contact with moving chain.

WARNING: Cutting edges on chain

are sharp. Use protective gloves when

handling chain.

Keep chain sharp. Your saw will cut faster and more

safely. A dull chain will cause undue sprocket, guide

bar, chain, and motor wear. If you must `f_rce chain

into wood and cutting creates only sawdust with ,few

large chips, chain is dull.

z / " _ Burr

,,// /

///

,,//

,-//

,,//

///

Flat File ,,,/ /

¢-//

///

- Guide Bar

/ Oil Slot

Figure 19 - Guide Bar Maintenance

1 2 ... 11 12 13 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire

Remington RM1632A Manuel du propriétaire Page 16

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à chaîne Remington RM1632A