Remington BS188A Manuel du propriétaire télécharger pdf (Page 11)

CHAIN SAW INFORMATION

CHAIN SAW ASSEMBLY

_1= WARNING: Cutting edges on

chain are sharp. Use protective

gloves when handling chain.

1. Align rib on chain saw power head with

groove in main handle (see Figure 5).

2. Slide power head into main handle until

units "snap" together (see Figure 6).

IMPORTANT."Both release buttons on

main handle must be fully engaged.

3. Slide battery onto main handle until

release buttons "snap" together (see

Figure 7).

Note: Fully charge battery before using

for first time. See Charging BatteJy.

Figure 6 - Assembled Power Head

Main Handle

Main Handle

3.

Pull chain with light force 1/8" away

from bottom of guide bar and release

(see Figure 8). If chain lightly snaps

back into place, tension is correct.

A slight sag (1/16" or less) between

chain and bottom of guide bar is

acceptable.

NOTE: Your Remington Cordless Polesaw

and Cordless Chainsaw may have been

purchased together (as a 2-in-I polesaw/

chainsaw) or seperate (chainsaw only). If

the chainsaw was purchased separately, the

pole is available as an accessory and may be

purchased by visiting the "On-Line Outlet"

at www.desatech.com.

Groove

Rib /

J

Main

Handle

Power Head

Figure 5 - Align Power Head with

Handle

Battery

Figure 7-Assemble Battery onto Main

Handle

SAW CHAIN TENSION

_IL WARNING: Remove battery from

chain saw beforeadjusting sawchain

tension. Severe injury or death

could occur from body contact with

moving chain.

_k WARNING: Cutting edges on

chain are sharp. Use protective

gloves when handling chain.

=I=

dl& WARNING: Maintain proper

chain tension always.AIoosechain

will increase the risk of kickback. A

loose chain may jump out of guide

bar groove. This may injure op-

erator and damage chain. A loose

chain will cause chain, guide bar,

and sprocket to wear rapidly.

Note: The saw chain tension is properly set at

the factory. A new chain will stretch. Check

new chain tension frequently (after discon-

necting battery) during the first 2 hours of

operation. Allow chain to cool down. Follow

steps below to check saw chain tension.

1. Remove battery from chain saw.

2. Place chain saw on a firm surface to

check chain tension.

Figure 8 - Check Chain Tension

Saw Chain Tension Adjustment

1. Loosen guide bar nuts before adjust-

ing chain (see Figure 9).

Guide Bar Nuts

Figure 9 - Loosen Guide Bar Nuts

2. Turn adjusting screw on front of

power head clockwise until slack is

out of chain (see Figure 10).

3. Wearing protective gloves, pull down

on chain to check chain tension (See

Step 3 Saw Chain Tension).

Screw

Figure 10- Turning Adjusting Screw

11 www. remingtonpowertoo/s, com

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 46 47

Commentaires sur ces manuels

Pas de commentaire