Remington BS188A Manuel du propriétaire Page 19

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 47
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 18
TROUBLESHOOTING
_ote. For additional help, v=sltDESA Power Tools' techmcal service web site at www.remingtonpowertools.com. i
WARNING: Remove battery from chain saw before adjusting saw chain tension. Severe injury or death could oc-
cur from body contact with moving chain.
O; " D ' '@ ;
Saw runs. but does not cut 1. Chain assembled backwm'ds on 1. See Replacing Saw Chain
guide bar,
I. Chain is dull, I. See Sharpening Saw ChainSaw does not cut unless heavily forced.
Cutting produces only sawdust with
few large chips
Saw runs slow. Saw stalls easily
Motor of saw does not run when you
squeeze trigger
Motor of saw runs, but chain does
not move
Chain comes oft"guide bar
Batter 3' dies quickly
Battery not charging
1. Battery is nemly depleted
1. Battery not installed properly,
2. Battery not chaged,
3. Trigger lockout not pressed in to
release trigger,
4. Worn out motor brushes,
5. Open wiring circuit on saw
1. Gear train failure
1. Chain is loose
2. Guide bar and chain not
assembled correctly
I. Battery not fully charged
2. Chain tension too tight
3. Old battery that does not hold
charge.
l. Charger not plugged in
2. Charger cord not plugged into
charger base
3. Battery not fully inserted into
charger base.
4. Battery is too hot Iron] use.
t. Recharge battery completely
until red LED turns oft.
1. Verify battery is installed
properly,
2, Check batteu charging
requirements.
3. Press in trigger lockout before
squeezing trigger,
4. Contact DESA Power Tools
Technical Service.
5, Contact DESA Power Tools
Technical Service.
I. Contact DESA Power Tools
Technical Service.
1. Tighten chain. See Saw Chain
Tension
2. See Replacing Saw Chain
1. Recharge battery completely
2. See Saw Chain Tension and
Adjusting Saw Chain Tension
3. Replace battery
1. Plug charger into 120V 60HZ
AC source
2. Ensure charger cord is fully
inserted into charger base.
3. Slide battery fully into chm'ger
base
4. Allow battery to cool for 30
minutes before placing in the
charger.
rrl
z
ffJ
r"
n
3::
19 www. rem/t)gtot)poweitools, corn
Vue de la page 18
1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 46 47

Commentaires sur ces manuels

Pas de commentaire